Marine & Door Spar Varnish
Last•n•Last Marine and Door Spar Varnish will provide outstanding protection for all types of exterior woodwork. Formulated to resist mold and mildew, it is the clear choice for exterior protection of wood. Manufactured using the highest quality resins, Last•n•Last Marine and Door Spar Varnish will provide outstanding beauty and durability. It contains UV absorbers for long lasting protection from the sun . Adhesion is excellent – resists flaking and chipping.

RECOMMENDED USES:
For Exterior wood surfaces; including wooden boat above the water line,doors,trims,outdoor furnitures,crafts,and railing . Not recommended for decks and sidings.

TYPICAL PROPERTIES
Color in Container: Amber
Solids Content Weight: 51+/-1% for Gloss
52+/- 1% for Satin
Chemical Resistance: Excellent
VOC: 450 g/l
Flash Point 105°F
Sheen Gloss: No less than 90 units @ 60° on wood
Satin: 50-60 units @ 60° on wood
Freeze/Thaw Stability Stable
Dry Time: 4-6 hours under good conditions
Clean Up: Mineral Spirits
Application method: Good quality brush, or spray
Coverage Approx. :500 sq. feet per gallon.

Proper surface preparation is essential to achieve a high quality finish. Read the MSDS sheet and wear proper protection, which may include gloves, eye protection, and/or other protective devices.

Surface Preparation:
New or Newly Sanded Wood Surfaces:Make several passes with the sandpaper, increasing the paper fineness with each pass. The final pass before application ofLast•n•Last Marine and door spar varnish should be with a #100 to #150 grit screen pad or sandpaper. Remove dust completely by sweeping, vacuuming and wiping the work surface with a lint free cloth lightly dampened with mineral spirits. The work surface and room temperature should be at least 65°F.

Previously Finished Wood Surfaces:
Remove old finish in poor condition. Screen the work surface with #180 grit sand paper, maroon pad or similar. Remove dust completely by sweeping, vacuuming and wiping the work surface with a lint free cloth lightly dampened with mineral spirits. The floor or work surface and room temperature should be at least 65°F.

Application:
Apply the finish with the grain of the wood. Apply in well ventilated area with a good quality brush . Avoid applying the finish in direct sunlight or when the weather is wet. Screen the work surface in between coats with any of the following, #180 grit sand paper, maroon pad or similar in between coats. Remember to vacuum and tack thoroughly after screening to remove all dust. Heavy finish application, high humidity or lack of airflow will extend drying times. If waiting longer than 24 hours between coats, sanding is recommended. On new wood, apply 3 coats for best results.

Drying Time:
When applied according to directions, and in thin coats, Last•n•Last Marine & Door Spar varnish should be dry to the touch in 4 hour. Allow minimum of 4 to6 hours between coats. Heavy finish application, high humidity or lack of airflow will extend drying times. Last·n·Last Marine & Door Spar varnish completely cures within 2 weeks.

Clean up:
Use paint thinner, mineral spirits or turpentine to clean brushes and applicators.

Maintenance:
We recommend to recoat it periodically depending on the severity of the outdoor conditions. We recommend Polycare Cleaner as the safe and effective cleaning product. It has a unique soap-free, no rinse formula which will not harm polyurethane or varnished wood surfaces.