Search: Advanced search
 
Printable version 
Categories Categories
Shop by Brand
Paints & Stains
Painting Tools
Paint Remover & Strippers
Solvents/Cleaners
Patching Materials
Tapes & Adhesives
Paint Sprayers & Accessorios


Bestsellers Bestsellers
1. UGL 13812 ZAR 138 SPANISH OAK WOOD STAIN SIZE:QUART.
2. UGL 01908 DRYLOK ETCH SIZE:12 OZ.
3. UGL 11006 ZAR 110 SALEM MAPLE WOOD STAIN SIZE:1/2 PINT.
4. UGL 27513 DRYLOK WHITE LATEX BASE WATERPROOFER READY MIXED SIZE:1 GALLON.
5. UGL 30507 DRYLOK GRAY MASONRY CRACK FILLER CARTRIDGE SIZE:10.5 OZ. PACK:10 PCS.


Manufacturers Manufacturers
3M
Absolute Coatings
Advance Protective Products
Akzo Nobel Paints LLC
Allway Tools
American Safety Razor
ASM
Cabot Stain
Convenience Products
Daich Coatings

Other manufacturers...


Special Special
Gift certificates


Help Help
Contact us
Privacy statement
Terms & Conditions
Sitemap
About Us
Tips for Painting

Paint Store :: Shop by Brand :: UGL :: UGL 28613 DRYLOK WHITE EXTREME WATERPROOFER SIZE:1 GALLON.

UGL 28613 DRYLOK WHITE EXTREME WATERPROOFER SIZE:1 GALLON.
UGL 28613 DRYLOK WHITE EXTREME WATERPROOFER SIZE:1 GALLON. 

DRYLOK® Extreme Latex-Base Masonry Waterproofer
The next generation in waterproof coatings. This smooth waterproof paint is perfect for the most demanding conditions. Ideal for interior, exterior, above or below grade masonry walls, basement walls, retaining walls, foundations, landscape walls, cinder blocks, concrete blocks, bare concrete swimming pools, stucco and brick. Flexible Encapsulated Polymer used for the ultimate in waterproof protection. Specially formulated to resist mildew growth on the paint film. Stops 12 psi, that’s greater than a wall of water 26 feet high! Passes ASTM D-7088 Resistance to Hydrostatic Pressure an ASTM D-6904 Resistance to Wind Driven Rain.

 

DESCRIPTION
DRYLOK EXTREME Latex Base Masonry Waterproofer is the Next Generation in waterproof coatings. Ideal for interior, exterior, above or below grade masonry walls, basement walls, retaining walls, foundations, landscape walls, cinder blocks, concrete blocks, bare concrete swimming pools, stucco and brick. Flexible Encapsulated Polymers are used for the ultimate in waterproof protection.
Specially formulated to resist mildew growth on the paint film. Certified to stop 12 psi, that’s greater than a wall of water 26 feet high!. Tested to ASTM D-7088 Resistance to Hydrostatic Pressure and ASTM D-6904 Resistance to Wind Driven Rain. Reduces radon gas penetration.

SURFACE PREP
May be applied on slightly damp surfaces, but best results are obtained when applied over dry surfaces. Wait for a dry (rain-free) period. Surface must be clean and free from dirt, dust, grease, oil, form release compound, frost or paint. Patch all holes or cracks with DRYLOK Fast Plug, or a fast setting hydraulic cement, and smooth the patch evenly with the surface around it. EFFLORESCENCE, a white, powdery, crystal-like deposit visible on the masonry surface must be removed. DRYLOK ETCH (liquid or powder formula) or Muriatic acid, used according to manufacturer’s directions, are effective efflorescence removal agents. Re-apply acid until all visible efflorescence is gone. Rinse thoroughly and allow to dry. DRYLOK Extreme may be applied over previous coatings in sound condition but the warranty is void. Not formulated for horizontal surfaces subject to foot traffic.

APPLICATION
STIR THOROUGHLY BEFORE AND DURING APPLICATION. DO NOT THIN. Air and surface temperatures must be 50°F, or higher. Apply first coat with a roller (3/4” nap), DRYLOK Brush or a good quality nylon bristle brush. If rolled, back brush the first coat to fill nay pinholes in the masonry. If brushed, work the DRYLOK into the pores of the masonry, making sure to fill all pores and pinholes (see COVERAGE). Apply at least two coats. Allow to dry 3 hours between coats. The second and subsequent coats may be applied by roller, brush or spray. When painting the inside of concrete fish ponds, allow DRYLOK Extreme to dry at least one week before putting into service.

CLEAN-UP
Clean application tools immediately after use in warm, soapy water.

IMPORTANT
After applying the second coat of DRYLOK EXTREME MASONRY WATERPROOFER, carefully inspect the entire wall surface for any pin holes in the waterproof coating. Any affected area should be painted with an additional coat to ensure satisfactory waterproofing results.

 
   

  47%

Details
 
SKU 7994128613
Quantity in stock 1000 item(s) available
Weight 17.00 lbs
Retail Price: $63.10
Our Price: $33.13

Options
 
Quantity

Add to cart
        


 

Send to friend
Your name: *
Your e-mail: *
Recipient's email: *

Type the characters you see in the picture. (If you do not see any picture here, please enable images in your web browser options and refresh this page):

Get a different code
The code is case-sensitive and must be entered exactly as above.

Send to friend
 

Detailed images
UGL 28613 DRYLOK WHITE EXTREME WATERPROOFER SIZE:1 GALLON.
 

Recommended products list
Customers who bought this product also bought the following products:  

 
 

Your cart Your cart
Cart is empty
 

View cart
Checkout
Orders history


Authentication Authentication
Username

Password

Log in 
Register 
Recover password

If Javascript is disabled in your browser click here


News News


 


Popular Categories

Tapes

Spray Paint

Paint Brushes

Paint Tools

Caulk and Sealants

Paint Remover & Stripper

Hand Tools

Interior Paint

Exterior Paint

 

Popular Brands

ZAR

Valpar

Cabot

DAP

3M

ASM

 

Hammerite

Modern Masters

 

Best Seller Products

Duct Tape

Black Paint

White Paint

Blue Paint

Red Paint

Dap Plus

Chalk Board Paint

Gold Paint

Aluminum Paint

 
 

We accept major credit cards

credit cards logo
 
Home | Store | About Us | Search | Terms & Conditions | Privacy Statement | Contact Us | Directory | Site Map | News | Paint Store Blog
 
SEO by site SEO
 
 

CONNECT WITH US
Copyright 2005-2015 Paint Store - All Rights Reserved